JK-700 series lasers parts
Parts for JK-701, 701h, 702, 702h 703. Cabinets of new parts including Control panels, process shutters, safety shutters, lenses, mirrors, mounts, trigger boards, control boards, head boards, rods, flow tubes, pump chambers, reflectors, power supply lamp drivers, charging supplies, cooler parts, o-rings, relays, etc. Literally tons of parts, just call for your needs. Pictures to follow. Price...call for pricing
Spectron Parts1 model PS 12 control tray, ps 12 amp #0035;(2) ps 12 control tray DAG-0035;1 ps12a amp tray-ps12a-0035;(2) cooling drawer 220-1-68. Various mounts, amp and oscillator pump chambers with all parts including rods, lamps, filter glass, etc. Price......call
|
Affinity FAA-0320D Chiller
30 Kw of cooling, 208-240 volt 3 phase, with manual. Very good condition. Price.....call for pricing
A.E.C 8.5 ton air cooled chiller
In excellent condition with low usage, manual, 220 volt 3 phase. See Spec. page below. Price...call for pricing
Alpha 25 Ton
Air cooled chiller model PCAL-SH-NF-25-460 -The model NF-25-460 air cooled chiller is in excellent condition. It has a capacity of 88 kw, or 300,000 btu's per hour, with a 4 hp pump 46 gallons per minute at 65 psi pressure. This unit takes 45 amps per phase at 460v. Approximate shipping weight is 2800 pounds. Comes with manual, and is in excellent working condition. Price........Call for Pricing
New 25 Ton Carlyle compressor
Model number 06EX265-360. This unit is new in the original box. Comes with installation kit, manual. Price.......Call for Pricing
Spectra Physics autocorellator model 409
In very good condition, this scanning autocorellator will scan 80 ps + 40 ps shift. Pulse-width resolution < .5ps. Price......call for pricing
AEC 2-Hp. Chiller
Model PSA-2 with 2 Hp compressor and 3/4 Hp circulating pump, manufactured 1997, air cooled, excellent condition ....$ 2,000 each (2 available)
4 x 5' x 8" Optical table
excellent condition. Price.......Call for pricing
Oriel Breadboard
Oriel 30" wide x 6' long x 8" with 1/4-20 tapped holes on 1" centers, excellent condition. Price......Call for Pricing
Newport 3' x 6' x 8" optical table
Top in excellent condition with 1/4-20 tapped holes on a 1" grid. Solid legs available. Price........Call for pricing.
Newport XLB series pneumatic isolation legs
Note, that only one set of "air legs" are available with purchase of table top at an extra charge. The legs will go with any one of our table tops.
Newport 4' x 5' x 12" optical table bolt on end section
Top in excellent condition with 1/4-20 tapped holes on a 1" grid. 2 20" solid legs bolted on the far end support. Table is shown in the upside down position for shipping. 6" from bolt end is a 20" x 20" factory cut-out. Price.....Call for pricing
Newport 10' x 4' x8" optical table with solid legs
Top in excellent condition with 1/4-20 tapped holes on a 1" grid. Solid legs available, also 2 tables available.Price......Call for pricing
Optics for Research isolator-Yag
large yag isolator with small chip at edge. 16mm full aperture, with 13mm useable. Price.. Call for pricing
Koolant Kooler model KV-3000
Rated 3 hp, with 1.5 hp circulating pump, 480 volt @ 8.75 amps. Unit is in good working condition. Price.....Call for Pricing
Hewlett Packard 5500C, 5517C Interferometer heads
Three HP 5500C laser heads and 1 5517C laser head. Cables available.......Price................Call for Pricing
Neslab CFT-75-A
Excellent condition. Price........................$call
Spectra Physics / Lasermetrics Harmonic Generators
Various types in good condition. Call for Pricing.
AEC model DLA-3 chiller
w/ digital control / rated 9.3 KW @ 13 degrees C / about 10.5 KW at 20 degrees C / water-cooled / special large pump (1.5 hp) / 440V three-phase power / mfrd. '87 / many nice features / very good condition / can demo.....$800
Laser Drive Model LDI 830 Diode Supply, and SDL 800 M
2000 ma supply - ..................Call for Pricing.
SDL 820
Laser Diode Driver CW/Pulsed 10 amp.........................Call for pricing.
SDL-822 diode driver
SDL-822, 15 amp diode driver with TE cooler, excellent condition. Price....Call for pricing.
Lumonics Fiber beam delivery heads
Lumonics fiber beam delivery heads with 1" camera "through the lens" viewing port. These units are ready for a camera to be mounted with the x-y adjustable 1" mount for the camera. Also in stock are 2-5 meter 1000 micron fibers for JK-701. Excellent condition........................Call for Pricing
Newport linear stage with rotary
in very good condition 24" stage with 3" rotary bolted on. Price......call for pricing
Newport Rotary stages models RV120CCHL-F(small), RV240HAHL(large)
Excellent condition. Price.....Call for Pricing
Newport Rotary Stage model RV120CCHL-F
Excellent condition. Price........Call for pricing
Opto Power 810-808 nm Fiber Diode with Controller
Model OPC-A015-810-FCPS, mf'd. 1997 with 95 hours use. Unit in excellent condition with output over 20 watts from the fiber. SMA connector, temperature management and power controller with remote pendant control. 4 available- Price...................$call
General Photonics YAG Laser Head
Two-43 YAG Laser head with Cleveland Crystals Q-switch, pump chamber, rod and optics, ready to go in excellent condition - just add power supply. (3 available) Price.......................$call
Quantronix 117 pump chamber
This pumping chamber is brand new and identical to the q-117 chamber other than the water inlet and outlet is on the bottom. New lamp + jacket; new rod + jacket; new reflectors.....Price.................$call
Laser Photonics YAG Laser Head and Water Cooler
Q-switched rated 150 mj/pulse @ 10 ns @ 20 hz with water circulator, hoses, cables, just needs power supply. Head in excellent condition. Price.....................................$call
SU-256LD InGaAs Photodiode array with T/E cooling
Spec pages displayed. Nearly 2.5 micron sensitivity wavelength. Four brand new units available with manual.Price....Call for Pricing
Lasermetrics LM-5016 Pulse Timing Unit Driver and Q-Switch
Krytron fired with time delay generator. Price..................................$call
Lumonics Q-Switch Driver for Lightwriter SPe
Mfd. 2003, excellent condition. Price..........................$call
Coherent Optics
Hundreds of new Coherent Optics for various systems in stock. Inquire with part numbers. Call for Pricing.
Lasag
Lasag Fiber and 90 degree camera ready beam delivery head. Fiber is new in the original box, beam delivery head is slightly used, in excellent condition. Price..................$call for individual pricing.
Hamamatsu Phototube Model R1193U-01
New in the original box..........Call for Pricing
Control Laser Q-Switch Driver
...............$call
New Focus model V8801 Multi Axis Pico Motor Driver
w/ 2 model V8051 Pico Motor Stages and model V8620 Control Pendant. Price................$call
ILX Lightwave 3722B
w/ TE cooler controller / range: 0-200 and 0-500 mA (selectable).....$call
ILX Lightwave Laser Diode Driver including TE cooler
Model 3744B, with TE controller, IEE-488 controller port, 4000ma, excellent condition. Price......................$call
Laser Diode Driver 200 amp
Tutcore Electronics Model 200A manufactured 2000 with RS-232 for control, 1200 watt 120V. Price................$call
Cassegrain Thermal/IR Telescope
This telescope has a 7" diameter main mirror and a gallium-arsenide output lens of about 2" diameter. This was manufactured for Raytheon and comes in a nice carrying case. It is made for optical table mounting and has a focus adjuster on the front (top). Price...................$call
Melles Griot 532nm Telescope
Up-collimating precision telescope for 532 nm. New in carrying case. Appears to be 20 x, but will confirm. Input aperture approximately 5 nm. Output aperture 25 nm. Comes with calibration and specification sheets. Price..............$call
Spectra Physics dye pumps and dye laser motor scan controllers
(several of each available)
Dye pumps.....$call ea.
Controllers.....$call ea.
Dye pumps.....$call ea.
Controllers.....$call ea.
Thyratrons
Many styles and sizes, new and used. (over 100 available) Call for pricing.
Multiple manual adjustment stages
(call for details, many available) Melles Griot X-Y-Z compound adjustment fiber alignment stages / Newport X-Y-tilt stages.....Call for pricing
Choppers with or without drivers
.....Call for pricing
JK Lumonics Power share and time share modules
many modules both time and power share along with 600 micron fibers available. We can configure the modules and outputs to your needs. Call for pricing.
Three way power share for JK-700 Series laser
.....$call
Two way time share for JK-700 Series laser
pneumatically operated.....$call
ESI YAG Pump Chamber
New lamp and rod Model 3800....$call